Pool and Spa Combination Layout Guide
A spa attached to a pool isn't just a smaller, hotter section of the same water, it's a separate plumbing and heating zone layered into one design. Because each Memorial Village is its own municipality, pool permits are pulled through that specific village rather than one shared county office, and that permitting path is confirmed as part of design planning.
Raised Spillover vs. In-Line
A raised spillover spa sits above the pool deck level with water spilling over its wall into the pool, giving a visual and sound feature in addition to a separate soaking space. An in-line spa sits at pool level, separated by a low wall or nothing at all, simpler and less expensive to build but without the spillover visual.
Separate Heating, Shared Pump (Usually)
A spa needs to heat and circulate independently from the main pool (so it can run hot without heating the whole pool), which usually means a separate heater zone and valve-controlled plumbing even when both share the same pump, a detail that gets engineered during design, not improvised later.
Where This Fits
See our Gunite Pools service page, or Financing if cost is the next question.
Related Reading
Gunite vs. Fiberglass vs. Vinyl Pools
A straight comparison of construction method, cost, timeline, and maintenance across the three main pool types.
Negative-Edge Pools Explained
What a vanishing/infinity edge actually requires from a lot, and what it adds to a build.
Pool Cleaners Compared: Robotic, Automatic, and Manual
How robotic, pressure/suction automatic cleaners, and manual vacuuming compare on cost, effort, and cleaning quality.
Get a Free Quote
Tell us about your project and we’ll follow up within one business day.